801
Throttle Actuator Motor
The fixings for the throttle actuator motor and the butterfly hard stop adjustment
screws are marked with yellow paint and must not be loosened or removed.
If the fixings or adjustment screws have been loosened or removed the throttle body
assembly must be replaced as there are no means to reset the throttle actuator motor
to its correct position.
The throttle actuator motor is an integral part of the throttle body and cannot be
adjusted or replaced separately.
The only adjustment permitted on the throttle body is throttle balance adjustment (see
Throttle Body Balancing).
Ignition Coils – Removal
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Perform the following operations:
• Seat - Removal
• Battery - Removal
• Fuel Tank - Removal
• Evaporative Canister - Removal
To Next Page
Loading...
