1. The ignition coil harnesses are identified by coloured tape as follows:
White - Number one cylinder
Red - Number two cylinder
Blue - Number three cylinder
2. Note the routing and position of the six wires connected to the ignition coils for
installation.
3. Note the routings of the high tension cables for installation.
1. Disconnect the six wires from the ignition coils.
2. Remove and discard the fixings securing the ignition coils to their brackets. discard
the fixings.
1. Ignition coil connections (Number one cylinder)
2. Ignition coil connections (Number two cylinder)
3. Ignition coil connections (Number three cylinder)
4. Fixings
3. Disconnect the high tension cables from the spark plugs and remove the ignition
coils.
To Next Page
Loading...
