Triumph Rocket 3 GT 2021 - Page 211

183
Do not replace individual brake pads; replace both pads in the brake caliper. On the
front where two calipers are mounted on the same wheel, all the pads in both calipers
must be replaced simultaneously. Replacing individual pads will reduce braking
efficiency and may cause loss of motorcycle control and an accident.
In accordance with the Scheduled Maintenance chart, inspect the brake pads for wear.
The minimum thickness of lining material for any front or rear brake pad is 1.5 mm. If
any pad has worn to the bottom of the groove in the pad centre, replace all the brake
pads on that wheel.
1. Brake pads
2. Minimum thickness line