401
1. Actuator knuckle
2. Actuator shaft
3. Return spring ends
4. Dowel
9. Position the crankshaft scraper as noted for removal.
10. Fit the bolts into the lower crankcase as noted for removal and hand tighten until the
bolt heads are near contact with the crankcase. Hardened washers to be fitted to
bolts 1 to 8.
11. Tighten the lower crankcase fixings in the following three stages:
Stage 1
12. Tighten the fixings 1 to 27 in the sequence shown to 10 Nm.
Stage 2
13. Release the fixings 1 to 8 in the sequence shown by 140°.
14. Retighten the fixings 1 to 8 in the sequence shown to 10 Nm.
To Next Page
Loading...
