Triumph Rocket 3 GT 2021 - Page 442

414
NOTICE
Note the orientation of the crankcase breather hose for installation.
5. Release the clamp and remove the crankcase breather hose.
Crankcase – Assembly
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Transmission Bearing Cap
3. Fit a new O-ring to the oil dowel on the transmission bearing cap.
Transmission Cover
3. Fit a new O-ring to the original oil spray bar.
4. Fit the spray bar to the transmission cover. Secure with two new fixings and tighten
to 4 Nm.