528
Oil Pump – Assembly
1. Fit the pressure rotor dowel to the second hole away from the E-clip recess in the oil
pump drive shaft.
2. Fit the pressure inner rotor to the drive shaft from E-clip recess end, make sure the
recess in the rotor fits over the dowel.
3. Fit the rotor outer and oil pump housing to the drive shaft as noted for removal.
1. Outer rotor
2. Inner rotor
3. Oil pump housing
4. Dowel
5. Oil pump drive shaft
4. Fit the oil pump pressure housing to the pressure rotors. Make sure the pressure
relief valve is correctly aligned and the pressure end plate is fitted as noted for
removal.
To Next Page
Loading...
