617
Cruise Control Switch Check
The cruise control switch check is required after certain DTCs or defects have been
repaired which relate to the ride by wire system or cruise control system, or after the
adaptions have been reset. The switch check requires the user to operate the switches in
order, following the instructions on screen.
The following switches will be checked:
• Front brake switch
• Rear brake switch
• Clutch switch
• Twist grip cruise cancel switch (operated by holding the twistgrip in the fully
closed position)
• Cruise control accelerate switch
• Cruise control decelerate switch.
A malfunction of any switch will not necessarily cause a DTC to be stored and may
prevent the cruise control from operating correctly.
If the cruise control switch check is not carried out, the green cruise control warning
light will illuminate when the ignition is turned to the ON position but the cruise
function will be disabled.
To Next Page
Loading...
