752
Fuel Pump Assembly – Inspection
1. Inspect all hoses for cracks, splits, fraying and other damage. Replace as necessary.
2. Check all hose clamps for cracks and signs of distortion. Replace as necessary.
3. Check the mesh filter for damage and replace if necessary.
Fuel Pump Assembly – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Observe the warning advice given in the General Information section on the safe
handling of fuel and fuel containers.
Before disconnecting any fuel lines, make sure the engine and exhaust system has
cooled down.
A fire, causing personal injury and damage to property could result from spilled fuel or
fuel not handled or stored correctly.
Never drain fuel from the tank using non-approved, non-professional standard fuel
handling equipment. A fire causing destruction of property and injury to persons may
result from use of non-approved fuel handling equipment.
1. Position a new fuel pump plate seal on to the fuel pump plate.
To Next Page
Loading...
