Triumph Rocket 3 GT 2021 - Page 848

810
Manifold Absolute Pressure (MAP) Sensor – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Connect the MAP sensor hose and the electrical connector to the MAP sensor as
noted for removal.
2. Fit the MAP sensor to its mounting and tighten the new fixing to 3 Nm.
1. Fixing
2. MAP sensor
3. Connector
4. Hose
Perform the following operations:
• Fuel Tank - Installation
• Battery - Installation
• Seat - Installation