Triumph Rocket 3 GT 2021 - Page 942

904
1. If the damper rod is to be removed, loosen the damper fixing at the bottom of the
fork by a half turn.
1. Damping cylinder fixing location
2. Drain the fork oil (see Fork Oil Renew - Draining).
NOTICE
The fork seals can be renewed without removal of the damping cylinder. Unless
removal of the damping cylinder is necessary, omit steps 16 and 17 of this procedure.
Never tightly clamp the outer tube as this will cause the tube to permanently distort. A
distorted tube is not serviceable and must be replaced.