Move the handlebars to the left and right full lock while checking that cables and
harnesses do not bind or that the steering feels tight or difficult to turn. A cable or
harness that binds, or steering that is tight/difficult to turn will restrict the steering and
may cause loss of control and an accident.
7. Route and secure the ABS wheel speed sensor harness as noted for removal and fit
the wheel speed sensor and shim to the fork leg. Tighten the new fixing to 9 Nm.
Perform the following operations:
• Front Mudguard - Installation
• Front Wheel - Installation
• The air gap between the ABS pulser ring and the sensor must be between 0.37
mm and 1.23 mm. Check, and if necessary, adjust the air gap (see Air Gap
Measurement)
Front Fork – Disassembly
Do not change the fork adjustment settings. If they are changed, this will change the
handling of the motorcycle from those which the rider is used to. Riding with
unfamiliar fork settings may cause unexpected handling characteristics leading to loss
of control and an accident.
To Next Page
Loading...
