917
5. Remove the cable tie securing the switch housing wiring harness to the left hand
switch housing.
6. Gently pull on the wiring harness to disconnect the switch housing connectors.
The service tool T3880369 is required to release the handlebar switch housings from
their retaining clips.
When inserting service tool T3880369 into the switch housing, a click can be felt/heard
as the retaining clip is released.
The retaining clip will remain in position on the handle bar as the switch housing is
removed. Note the position and orientation of the clip for installation.
7. Insert service tool T3880369 into the opening on the left hand switch housing until a
click is felt/heard.
1. Left hand switch housing
2. Opening
3. T3880369 - Switch Housing Removal Tool
8. Slide the switch housing towards the end of the handlebar to free it from the
retaining clip.
9. Withdraw service tool T3880369 from the switch housing.
To Next Page
Loading...
