Suspension Setting Chart - Speed Triple S
Warning
Make sure that the correct balance be-
tween front and rear suspension is
maintained.
Suspension imbalance could signifi-
cantly change handling characteristics
leading to loss of control and an acci-
dent.
Refer to the chart below for further in-
formation or consult your dealer.
Warning
Make sure that the adjusters are set
to the same setting on both forks.
Settings which vary from left to right
could significantly change handling
characteristics leading to loss of con-
trol and an accident.
The standard suspension settings provide a comfortable ride and good handling
characteristics for general, solo riding. The chart shows suggested settings for the
front and rear suspension.
LOADING FRONT REAR
Spring Pre-
Load¹
Rebound
Damping¹
Compression
Damping¹
Rebound
Damping¹
Compression
Damping¹
Solo Riding Road 8 2.5 2 2.5 2
Comfort 8 2.75² 3² 2.75² 3²
Track 8 1 0.5 0.75 0.5
Sport 8 1.5 1.5 1.5 1.5
Rider and Passenger 8 1.5 1.5 1 1
¹ Number of adjuster turns anticlockwise from the fully clockwise position.
² Number of maximum adjuster turns unless already fully screwed out.
Note:
• The Speed Triple S motorcycle is delivered from the factory with the suspension
set at the Road riding settings, as shown in the relevant suspension chart.
Note:
• These charts are only a guide. Setting requirements may vary for rider weight
and personal preferences. See the following pages for information regarding
suspension adjustment.
To Next Page
Loading...
Need help?
General
