The accessory kits covered in this instruction are
designed for use on specific models of Triumph
motorcycle. The accessory kits and the models
applicable are listed at the start of the instruction. They
should not be fitted to any other Triumph model or to
any other manufacturer’s motorcycle. Fitting an
accessory kit to a Triumph model not listed, or to any
other manufacturer’s motorcycle will affect the
performance, stability and handling of the motorcycle.
This may affect the rider’s ability to control the
motorcycle and could cause an accident.
Always have Triumph approved parts, accessories and
conversions fitted by a trained technician of an
authorised Triumph dealer. The fitment of parts,
accessories and conversions by a technician who is not
of an authorised Triumph dealer may affect the
handling, stability or other aspects of the motorcycle’s
operation which may result in loss of motorcycle control
and an accident.
Throughout this operation, ensure that the motorcycle is
stabilised and adequately supported to prevent risk of
injury from the motorcycle falling.
If the engine has recently been running, the exhaust
system will be hot. Before working on or near the
exhaust system, allow sufficient time for the system to
cool, as touching any part of a hot exhaust could cause
burn injuries.
The tail pack must not be fitted to the sliding carriage
(if fitted). If a sliding carriage is fitted, the tail pack must
either be fitted to the pillion seat, or the sliding carriage
must be removed and the bike reverted to its standard
condition prior to fitting the tail pack to the rear rack.
Installation of the tail pack on to the sliding carriage will
affect the handling, stability or other aspects of the
motorcycle’s operation which may result in loss of
motorcycle control and an accident.
The tail pack must not be fitted in conjunction with a top
box. Installation of the tail pack together with a top box
will affect the handling, stability or other aspects of the
motorcycles’s operation which may result in loss of
motorcycle control and an accident.
Install the tail pack only in the positions described below.
Installation of the tail pack in any other position on the
motorcycle will affect the handling, stability or other
aspects of the motorcycle’s operation which may result
in loss of motorcycle control and an accident.
Remove all straps from the motorcycle when operating
the motorcycle with the tail pack removed. Operation of
the motorcycle with the straps fitted, and the tail pack
removed, may result in loss of motorcycle control and
an accident.
Remove the shoulder strap(s) from the tail pack before
mounting to the motorcycle.
Operation of the motorcycle with the shoulder strap(s)
fitted may result in loss of motorcycle control and an
accident.
50 Litre Tail Pack only: Secure the carry handles in to
the zipped compartments on either side of the tail pack
before mounting to the motorcycle.
Operation of the motorcycle with the carry handles
unsecured may result in loss of motorcycle control and
an accident.
Always ensure the tail pack straps are correctly
tensioned before riding the motorcycle. Operation of
the motorcycle with the tail pack loose may result in loss
of motorcycle control and an accident.
To Next Page
Loading...
Need help?
General
