needle, Centralization of jet, To assemble carburetor(s),
To adjust fuel level in float chamber,
Carburetor tuning,
Carburetor defects (pistons sticking, eccentricity of jet
and needle, flooding from float chamber or mouth of jet,
leakage from bottom of jet adjacent to adjustment nut,
dirt in carburetor, failure of fuel supply to float chamber,
sticking jet)
Q.
SPECIALIZED TOOLS
.................................................
385
Policy, Particulars of tools, Tool list
R.
BRAKES
.........................................................................
389
Description, Routine maintenance, Brake lining iden-
tifications, Data, Front brake shoe adjustment, Rear
brake shoe adjustment, Handbrake adjustment, To bleed
hydraulic system, Leakage of fluid from master cylinder,
Brake and clutch pedal adjustment, Adjusting brake
pedal, To remove front left-hand flexible hose, To fit
front left-hand flexible hose, To remove front right-hand
flexible hose, To fit front right-hand flexible hose, To
remove rear flexible hose, To fit rear flexible hose, Twin
bore master cylinder (description), To remove master
cylinder, To fit master cylinder, To dismantle master
cylinder, To assemble master cylinder, Front wheel
cylinders, To remove front wheel cylinders, To fit front
wheel cylinders, To dismantle front wheel cylinders, To
assemble front wheel cylinders, Rear wheel cylinder, To
remove rear wheel cylinder, To fit rear wheel cylinder, To
dismantle rear wheel cylinder, To assemble rear wheel
cylinder, To remove hydraulic pipe line from rear axle,
To fit hydraulic pipe line to rear axle, Fitting replace-
ment brake shoes, To remove pedal assembly, To fit
pedal assembly, To dismantle pedal assembly, To assem-
ble pedals, To remove handbrake lever, To fit handbrake
lever, To dismantle handbrake assembly, To assemble
handbrake assembly, To remove handbrake cables, To
fit handbrake cables
................
....................................
S.
EXHAUST SYSTEM
....
411
Description, Maintenance, To remove and dismantle ex-
haust system, To fit exhaust system, To remove
manifolds. To fit manifolds
SUPPLEMENT FOR TR3 MODELS
..............................
417
Foreword, General data, Engine (cylinder block,
aluminum pedestals for rocker shaft, pistons, combus-
tion head, engine oil filter, sump), Clutch (clutch driven
plate assembly, hydraulic operating mechanism), Rear
axle (general, lubrication of rear hub bearings, axle shaft,
wheel bearings and oil seals, differential and pinion as-
semblies, high speed and competition work), Front
suspension and steering (nylon bearings, lower inner
wishbone attachment), Body (specification, reveal
molding and grille, stainless steel wing beading, pas-
senger seat, occasional rear seat, to remove reveal
molding and grille, to refit reveal molding and grille, to
remove or fit wing beading, to remove passenger seat
squab, to fit passenger seat squab, to fit occasional seats,
to remove occasional seat, TR2
&
TR3 "hard top" in-
stallation-car preparation, hard top preparation,
windscreen (windshield) attachment brackets, bridge
pieces, rear
cappings, drip channels, sealing rubbers, to
fit hard
top, rear
window light), Fuel system (petrol tank,
flexible fuel pipes, carburetors, air cleaners, inlet
manifold, to remove flexible fuel hose assembly, to fit
flexible fuel hose assembly, carburetor details, air
cleaners, inlet manifold), Brakes (Girling brakes and
hydraulic clutch-from chassis No. TS.13101, front
brakes, discs, rear brakes, running adjustments,
hydraulic clutch operation, clutch slave cylinder, general
maintenance, general advice on hydraulic components),
Exhaust system
To Next Page
Loading...
