Need help?Do you have a question about the Triumph TR4 and is the answer not in the manual?
General| Brand | Triumph |
|---|---|
| Model | TR4 |
| Category | Automobile |
| Language | English |
Information regarding the procurement and quality of genuine spare parts.
Details on tachometer, speedometer, turn signal, and ignition warning lights.
Description of water temperature, oil pressure, fuel, and ammeter gauges.
Operation of lighting, washer, wiper, and ignition/starter switches.
Operation of headlamp dipper switch, horns, and overdrive control.
Controls for turn signals, pedals, gear shifting, and the handbrake lever.
How to operate the heater, blower, and air distribution controls for comfort.
Instructions for operating the facia locker, luggage compartment, and fuel filler cap locks.
Details on interior/exterior door locking and how to open the bonnet.
Procedures for starting the engine from cold/hot and the initial running-in period.
Recommended speed limits and advice on using the overdrive unit.
Importance of lubricants and details on the maintenance voucher scheme.
Daily checks for engine oil level and radiator water level.
Weekly checks for tyre pressure and battery electrolyte level.
Initial 500-mile service and checks for brake/clutch cylinders and propeller shaft.
Procedures for adjusting clutch, front/rear brakes, and handbrake.
Procedures for changing engine oil, topping up gearbox/axle, and servicing air cleaners.
Adjusting valve clearances, fan belt, and servicing carburetors and spark plugs.
Servicing the ignition distributor and checking/lubricating chassis attachments.
Procedure for packing front hubs with grease for normal and competition use.
De-dusting rear brake linings and lubricating rear hub bearings.
Lubricating steering unit/water pump and replacing spark plugs.
Procedures for draining, flushing the system, and maintaining the screen washer.
Guide for anti-freeze concentration based on temperature for frost protection.
Instructions for removing and refitting pressed steel and wire spoked wheels.
Safe vehicle jacking procedures and tyre pressure guidelines.
Explanation of Zenith-Stromberg carburettor operation during normal running and acceleration.
How to use the choke for cold engine starting and gradual release.
Adjusting throttle stop screw for speed and jet screw for mixture quality.
Synchronising twin carburetors and checking float chamber fuel level.
Procedure to centralise the jet and ensure free air valve movement.
Process for bleeding air from the brake and clutch hydraulic systems.
Adjusting the steering column and setting front wheel alignment.
Location/function of fuses and a chart of vehicle bulbs.
Details on ignition system function, cables, distributor, and contact points.
Operation and maintenance of the generator, control box, and starter motor.
Procedure for setting the ignition timing using the crankshaft pulley and distributor.
Instructions for aligning headlamps and replacing sealed beam light units.
Replacing bulbs in lamps and maintaining battery terminals.
Guidelines for washing, polishing paintwork, and cleaning the car's interior.
How to remove the soft top and maintain its fabric and frame.
Steps for unfolding and attaching the soft top to the frame and car body.
Information on fitting provision for two- or three-point safety harnesses.
Instructions for fitting the surrey top frame and securing it to the car body.
Table detailing recommended lubricants for various car components for home markets.
Summary table of lubrication/maintenance tasks with page references and intervals.
Key engine dimensions, compression ratio, valve timing, and ignition system settings.
Specifications for chassis, suspension, steering, and brake systems.
Details on fluid capacities for engine, gearbox, axle, and gear ratios.
Table showing road speeds at different engine speeds for tyre types and axles.
Recommended tyre pressures for various operating conditions and tyre makes.
To Next Page
