MAINTENANCE
(62) Checkladjust headlamp alignment b. To mix cross-ply tyres and radial-ply tyres on
See 86.40.18.
(63) Check,
if
necessary renew wiper blades
the same axle.
c.
To use a tyre that has a tread depth of less than
0.039 in
(l
.0
mm)
over three-quarters of the
tread width for the centre circumference of the
1. Examine each wiper blade in turn for damage.
tyre.
2.
With the wiper blades in position and the windscreen d. To use a car with the tyres inflated to a
wet, operate the wiper motor.
pressure that is not suitable for the use to
3.
Check the wiper blade operation for smearing and
which the vehicle is put.
adequate removal of dirt.
li
the tyres do not conform with legal requirements report
4. Stop the wiper motor.
to the owner.
5. If the checks
in
procedures
1
and
3
are not
satisfactory replace the wiper blades as necessary, see
84.15.05.
(69) Check that tyres comply with manufacturer's
specifications
(64)
Check output of charging system
See Division 04
Report any deviations that may influence the car's
performance or the accuracy of the speedometer.
FUEL
AND
EXHAUST PIPES
(70) Check tightness of road wheel fastenings
Check exhaust system for leaks and security
Check the security of the exhaust pipe to the
manifold nuts; tighten to the correct torque, 25 lbf
ft
(3.5 kgf m).
Check the security of the exhaust pipe joint clips.
Check the security of the exhaust system (and where
applicable the catalytic converter) mounting bolts.
Use a second operator, run the engine at fast idle
speed.
Check the exhaust system joints for leaks.
Check the exhaust pipes for leaks arising from
damage or deterioration.
Check the exhaust silencer for leaks arising from
damage or deterioration.
Stop the engine.
Report any defects found.
Refer to Division 06 for the torque settings.
(71) Check tyres for external cuts in the tyre fabric,
exposure of ply or cord structure, lumps or bulges
(72) Check tyres for tread depth, visually for external cuts
in tyre fabric, exposure of ply or cord structure,
lumps and bulges
BODY
(73)
Lubricate all locks and hinges (not steering lock)
Using an oil can sparingly, lubricate the items as
detailed.
(66) Check fuel system for leaks, pipes and unions for
chafing and corrosion
Wipe away any surplus oil to avoid staining paintwork
Report any defects.
or interior hinges.
(67) Check condition of fuel filer cap seal
(74)
Check condition and security of seats and seat belts
1. Make a visual check of the seal for the fuel tank filler
cap.
2.
Renew the seal if its condition is doubtful.
(75) Check rear view mirror for cracks and crazing
WHEELS
AND
TYRES
(76) Check operation of all door, bonnet and boot locks
(68)
Checkladjust tyre pressures, including spare wheel
Refer to Division 04 for pressure settings
(77) Check operation of seat belt warning system
WARNING:
It can be dangerous:
a.
To use a car fitted with tyres in a damaged
condition. (78) Check operation of window controls
To Next Page
Loading...
Need help?
General
