operateautomaticallyshutdown,theusercansetintherangeof10‐600seconds
Setthebuzzervolume:Settingrange0 ‐5,0meansmute
(2,wirelessconfiguration
Wireless communication configuration includes setting local address, wireless communication
channel,pairingwithwirelessbasestation.Thelocaladdressis1‐
99,thewirelesschannelis1‐32,
the same environment, multiple different wireless channel machines can be used at the same
timeandthebarcodedatawithoutdisturbingeachother.
Aftermodifyingthe wirelesschannel, the handset andthewirelessbase stationmustbe paired
before they can be used.
Matching principle is: a wireless base station can support multiple
machines,butthemachine'slocaladdresscannotbethesame.Thesameradiochannelmachine
can only use one wireless base station. Select pairing with wireless base station, follow the
instructionsonthemachinescreen,andconfirmwithENT.
(3,theapplicationupdates(needtoupgradeupdateonly)
ThePDTSeriesDataCollectorsupportsupgradingandupdatingapplications.Thedriversneedto
be installed for thefirsttime. The driverfiles areincluded in theapplication updatepackage. If
youneedtoupgradeorupgrade,pleasecontactthesales
andtechnicalpersonnelforupdating.
FCCCaution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This devicemaynot cause harmful interference, and (2) this device must accept
anyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.
Any Changes or modifications not expressly approved by
the party responsible for compliance
couldvoidtheuser'sauthoritytooperatetheequipment.
Note: This equipment hasbeen tested andfound to comply with thelimits for a ClassB digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful
interference in a residential installation. This equipment generates
usesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththe
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does
causeharmfulinterferencetoradioortelevisionreception,whichcan bedeterminedbyturning
the equipment off and on, the user is encouraged to try to correct the interference by one or
moreofthefollowingmeasures:
‐Reorientorrelocatethereceivingantenna.
‐Increasetheseparationbetweentheequipment
andreceiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
*RFwarningforPortabledevice:
ThedevicehasbeenevaluatedtomeetgeneralRFexposurerequirement.Thedevice
canbeused
inportableexposureconditionwithoutrestriction.
To Next Page
Loading...