TrolMaster Hydro-X - Page 12

12
2). When the Device 1 is selected, user can set the temperatue setpoint for Day / Night mode for the Device
1. The unit will automatically turn ON the Temp Device 1 when the measured temperature is ABOVE or
BELOW the setpoint. Press ENTER button and the Above or Below text will be flashing. Press UP or DOWN
button to change between Above and Below. Finally, press ENTER button to confirm and save the change.
For example: Turn on device when temp reaches Above setpoint for Cooling devices; Turn on device when
temp reaches the Below setpoint for Heating devices.
Use UP and DOWN button to select Day mode or Night mode, the selected item will be highlighted. Press
ENTER button and the current temperature value will be flashing. Press UP or DOWN button to change the
setpoint. Finally, press ENTER button to confirm and save the change. The LCD will display "Setting saved".
3). Press DOWN button to select and enter the Temp Alarm page. The screen will display the Min / Max
setpoint. Press UP or DOWN button to select the Min or Max setpoint. The selected item will be highlighted.
Then press ENTER button again, the current temperature setpoint will be flashing. Press UP or DOWN
button to change the setpoint. Finally, press ENTER button to confirm and save the change. The LCD will
display "Setting saved".
When the Temperature level exceeds the setting range, the unit will send a warning message to your
smartphone.
The setting procedure of other Temp Device Station is same as above.