16
Program Settings
Then press ENTER button again, the current CO2 setpoint will be flashing. Press UP or DOWN button to
change the setpoint. Finally, press ENTER button to confirm and save the change. The LCD will display
"Setting saved".
When the CO2 level exceeds the setting range, the unit will send a warning message to your smartphone.
The setting procedure of CO2 Device Station 2 is same as above.
1). On the Setting page, select the Program subject and then press ENTER button to confirm your
selection. The screen will display a total of 9 preset numbers: 1, 2, 3...9. You can assign total 9 additional
devices with the preset numbers from program device 1 to program device 9.
2). Press number 1 to enter into the Program Device 1 page. There are two timing control type: By Schedule
& By Recycle. Press ENTER button, the TICK icon will be highlighted and flashing. Then press UP or DOWN
button to select By Schedule or By Recycle. Finally, press ENTER button to confirm your selection and the
LCD will display "setting saved". Press UP or DOWN button to select the subdirectory you desire to change.
To Next Page
Loading...
