Microderm MD Quick Start Guide
FIRST Watch the DVD or Online Videos for detailed How-To Instructions
The MicrodermMD is simple and easy to use with just a little bit of practice.
It takes only 5 minutes to help get smooth, glowing, and youthful looking skin that is just
below the surface!
BEFORE TREATMENT
Step 1: Wash your face with a foaming cleanser of your choice, to remove all
dirt and oil. Gently pat dry.
Step 2: Connect the power adaptor to a wall power outlet, and then plug into the
back of the MicrodermMD.
Step 3: Press the Power button, and hear the motor cycle on for 2 seconds.
You can now choose either Auto or Manual modes.
AUTO MODE - Option 1 (Beginners)
This mode is excellent for beginners, as it will walk you through an entire treatment of
each zone of the face and neck. Press the Auto button, and then press Start/Stop
to begin the cycle.
The Auto Mode will display the zone of the face to treat on the screen, along with a
preset power level and a countdown timer. After the timer has run out, the screen will
move you along to the next zone of the face. Treating your entire face, neck and chest
takes just 5 minutes
MANUAL MODE - Option 2 (Advanced)
To switch to Manual Mode, press the Auto button once more. You can now control the
suction power level using the Up and Down buttons. We recommend switching to Manual
Mode after you become comfortable using your MicrodermMD.
AUTO
Register your Warranty today by visiting www.trophyskin.com/warranty
TREATMENT
ZONE
SUCTION
POWER
COUNTDOWN
TIMER
REV 07/2014
To Next Page
Need help?
General
