4 EN
voltage detector BE14
Information about the device
Device description
The voltage detector detects alternating voltage (AC) and signals
it to the user via a flashing LED and an acoustic signal.
The device can be used for finding a cable break or determining
the presence of alternating voltage in fuses, wires and cables.
Additionally the measuring device is equipped with an
integrated LED torch.
Device depiction
No. Designation
1 Power button LED torch
2 LED torch
3 Battery compartment with cover
4 Measuring tip
Technical data
Parameter Value
Detection range 200 V AC to 1000 V AC
Overvoltage category CAT IV 600 V, CAT III 1000 V
Degree of pollution 2
Battery type 2 x 1.5 V batteries AAA (Micro)
Weight 48.5g
Ambient conditions -10°C to 50°C with max.
95%RH
Storage conditions -10°C to 50°C with max.
95%RH
Scope of delivery
1xVoltage detector BE14
2 x 1.5 V batteries AAA (Micro)
1x Quick guide
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
When transporting the device, ensure dry conditions and and
protect the device from external influences e.g. by using a
suitable bag.
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• protected from dust and direct sunlight
• the storage temperature complies with the values specified
in the Technical data
• Remove the batteries from the device.