Need help?Do you have a question about the Trotec Speedy 100 and is the answer not in the manual?
General| Laser Type | CO2 Laser |
|---|---|
| Software | JobControl |
| Working Area | 610 x 305 mm |
| Laser Power | 30 - 60 W |
| Resolution | 1000 dpi |
| Interface | USB |
| Power Supply | 50/60 Hz |
Details the intended applications and materials for the Trotec Speedy 100 laser system.
Provides essential safety guidelines for all personnel involved with the machine.
Details laser safety classes, hazards, and precautions for laser radiation.
Lists crucial safety measures for operating the Speedy 100.
Explains the purpose and importance of warning and information labels on the device.
Provides step-by-step instructions for unpacking the Trotec Speedy 100.
Specifies the electrical requirements for operating the laser system safely and correctly.
Details the necessary specifications and considerations for the exhaust system.
Details the procedures for connecting the machine to power, computer, and exhaust.
Explains how to properly connect the laser device to the power supply.
Details the procedure for connecting the laser system to a computer.
Explains the function of the main ON/OFF switch and startup conditions.
Provides steps for performing initial engraving tests on the machine.
Provides general guidelines and procedures for cleaning the laser system.
Details the step-by-step process for cleaning the laser lens.
Provides instructions for cleaning mirrors #2 and #3 of the laser system.
Offers solutions for common problems encountered with the machine.
To Next Page
