Sheridan College
1
SPEEDY 300 LASER MANUEL
SPEEDY 300
The laser machine Speedy 300 in different version of Autocad makes it possible to cut and engrave
different materials with great accuracy (+/- 0.05mm). It is a good way to create an accurate model of your
design. This manual provides information on what should be done before using Speedy 300 and how to use
Speedy 300. Please read this manual carefully before start using Speedy 300. Note that the use of Speedy
300 is allowed only under supervision of qualified staff of the workshop.
Start with the machine setup!
Powering On:
After turning on the power, the table will drop to
the “zero” Z axis position. Do not interfere with the
laser while it’s doing this.
XYZ Controls:
• The red arrow keys control XY movement
• The black arrow keys control the Z axis
• The only other button you may use on this
control pad is the “Pause” button. DO NOT USE
AUTOFOCUS, IT DOES NOT WORK
To Next Page
Need help?
General
