Trotec TDS 10 M User Manual

6 EN
ceramic heater TDS 10 M / TDS 20 M
Assembly and start-up
Scope of delivery
• 1x Device
• 1 x Transport handle
• 2 x Screw
• 2x Washer
• 1x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Use tools suitable for the intended task.
Mounting the transport handle
Prior to initial start-up, the transport handle must be attached to
the device.
The procedure is identical for the devicesTDS 10 M/ TDS 20 M.
To do so, please proceed as follows:
1. Loosen the two screws and the two washers from the top
of the housing.
2. Use the screws and washers to mount the transport
handle.

Trotec TDS 10 M Specifications

General

Brand	Trotec
Model	TDS 10 M
Category	Heater
Language	English