EN 9
wet and dry vacuum cleaner VC 1200W
Changing the nozzles
You can attach all four nozzles to the suction pipe as well as
directly to the hose.
Attaching/detaching the nozzle to/from the suction pipe:
ü The device is switched off.
1. Detach the detergent pipe(2) from the suction pipe(12) by
turning the connecting piece in counter-clockwise
direction and then removing it.
2. Now remove the nozzle from the suction pipe(12).
3. Insert the connection side of the desired nozzle onto the
suction end of the suction pipe(12) (I.).
4. Insert the connecting piece of the detergent pipe(2) onto
the fitting of the suction pipe.
ð To do so, align the connecting piece so that the lugs on
the fitting match the recesses on the connecting piece.
5. Turn the connecting piece attached in clockwise direction
to fasten the connection (II.).
Attaching/detaching the nozzle to/from the hose:
ü The device is switched off.
1. Turn the two ends of the detergent pipe(2) in counter-
clockwise direction (I.) and release the connection.
2. Remove the nozzle from the suction end of the
hose(1)(II.).
3. Insert the connection side of the desired nozzle onto the
suction end of the hose(1) (I.).
4. Plug the two ends of the detergent pipe(2) together and
tighten them in clockwise direction (II.).
To Next Page
Loading...
Need help?
General