Accessories 1
Installation kit TQ FKR-EU
1
Order code detail
Application
– Square installation kit TQ (for FKR-EU
in construction with spigots) for dry mortarless
installation into lightweight partition walls with
metal support structure or steel substructure
and cladding on both sides, fire walls with
metal support structure and cladding on both
sides as well as into timber stud walls
and half- timbered constructions
– The installation kit is factory
mounted to the fire damper
– The unit is installed without a mortar
mix by simply inserting it into the prepared
installation opening
– In the event of a fire the intumescent
seal closes the remaining gap.
– A cover plate conceals any gaps
and is used for screw fixing
Materials and surfaces
– Installation kit made of calcium silicate
– Cover plate of the installation kit made of
galvanised sheet steel (and powder-coated
silver grey, RAL 7001, when used with powder-
coated (1) and stainless steel (2) dampers)
Note
For further information relevant to design,
in particular information on installation situations,
please refer to the operating
and installation manual.
Description
K4 – 1.1 – 13
Technical data
Accessories 1 Order code
Square installation kit TQ
Installation opening/cover plate dimensions [mm]
Nominal size 315 355 400 450 500 560 630 710 800
□A 435 475 520 570 620 680 750 830 920
□B1 515 555 600 650 700 760 830 910 1000
Weight in kg for FKR-EU with fusible link and installation kit TQ
Nominal size 315 355 400 450 500 560 630 710 800
Installation kit TQ 19.5 21.8 25.0 33.1 37.8 42.6 49.7 58.7 67.3
FKR-EU with spring return actuator: Weight + 1.8 kg (with BFN actuator) / + 3.0 kg (BF actuator).
03/2017 – DE/en
FKR-EU with square installation kit TQ
□
A
□
B1
④
③
①
②
①Installationkit
②Seal
③Coverplate
④Lightweightpartitionwallorfirewall
To Next Page
