Accessories 2
Cover grille FKR-EU
1
K4 – 1.1 – 14
Cover grille with extension
piece FKR-EU
Application
– If only one end is to be ducted on site,
the other end must have a cover grille
– For certain nominal sizes extension pieces
may be required, see table
– Fire damper, cover grille and,
if applicable, extension piece
are factory assembled to form a unit
– The free area of the cover grille is approx. 70%
– The fixing holes in the cover grilles
and extension pieces match those in the fire
damper flanges (applies only to FKR-EU-FL)
– Cover grilles are also available separately
– Cover grilles both ends are approved
in Germany only for Type FK-EU fire dampers
used as air transfer dampers, general building
inspectorate licence Z-6.50-2031
Materials and surfaces
– Cover grilles made of galvanised sheet steel
(and powder-coated silver grey, RAL 7001,
when used with powder-coated (1)
and stainless steel (2) dampers)
Note
For further information relevant to design,
in particular information on installation situations,
please refer to the operating
and installation manual.
Description
/ 0A /
/ AS /
/ SA /
Order code detail
Technical data
Cover grille for FKR-EU
Operating side Installation side Order code
Cover grille – A0
– Cover grille 0A
Cover grille Flexible connector AS
Flexible connector Cover grille SA
Arrangement and length of extension pieces (dimensions in mm)
Nominal size Operating side Installation side
Construction variant FKR-EU / FKR-EU-FL
315 175 / – 175 / 175
355 175 / – 175 / 175
400 175 / – 175 / 175
450 175 / – 175 / 175
500 175 / – 175 / 370
560 175 / – 370 / 370
630 175 / – 370 / 370
710 175 / – 370 / 370
800 175 / 175 370 / 370
03/2017 – DE/en
To Next Page
Loading...
