Troy-Bilt GTX 16 - Safety; Safety Alert Symbol and Introduction; Operator Training and Preparation

Section 1
Safety
Important!
Safe Operating Practices for This Unit
This is a safety alert symbol. It is used in this manual and on decals on the unit to alert you to .
potential
hazards. Whenever you see this symbol, read and obey the safety message that follows 1t.
Failure to obey the safety message could result in personal injury or property damage.
Introduction
1. Unit is capable of amputating
hands and feet and throwing
objects. Failure to observe the
following safety instructions could
result in serious injury or death.
2. Serious accidents which may cause
injury or property damage can occur
if the following safety guidelines are
not followed. Operator is solely
responsible for accidents or hazards
that occur when using unit.
Preventing accidents is the
responsibility of every equipment
operator. Accidents can be prevented.
Be careful before, during and
immediately after use of any powered
equipment. The following general
safety precautions must be fully
understood and followed during
operation. Review these instructions
frequently and never take chances. If
you do not understand any part of
this manual or need assistance,
contact your dealer or our service
department.
4
Training
1. Read, understand and follow all
instructions in this manual and on
unit before starling. A free
replacement manual is available from
the factory. To order a replacement
manual, contact the factory at the
address indicated in this manual.
Provide the model/serial number of
unit when ordering.
2. Read and understand the operator's
manual provided with each
attachment used with this unit.
3. Read the engine operation and
maintenance manual provided with
this unit before operation. Read and
follow all safety instructions provided
in that manual.
4. Only allow responsible adults, who
are familiar with the instructions, to
operate the unit.
5. Know the location and function of all
controls before operating unit. Know
how to stop engine and attachments
quickly in case of emergency.
Familiarize yourself with all safety and
operation decals on unit and
attachments. If these decals are
damaged or not legible, clean or
replace them as needed.
Preparation
1. Wear proper clothing when operating
unit. Always wear sturdy footwear
(preferably steel-toed shoes) and
hearing protection during operation.
a. Wear heavy leather gloves
whenever working near or
servicing any cutting edges on
unit.
b. Do not wear loose-fitting clothing,
jewelry, scarves, ties, etc., which
may get caught in moving parts.
Tie up or restrain long hair.
c. Do not operate unit while
barefoot. Do not wear sandals.
d. Wear long trousers.
e. Wear hearing protection.
2. Do not operate unit when tired, ill or
under the influence of alcohol and/or
other drugs.
3. Be prepared for an emergency. Keep
a first aid kit and fire extinguisher
handy. Keep emergency telephone
numbers for ambulance, fire, ~
hospital, doctor and rescue near your .. j
telephone.