EasyManua.ls Logo

Troy-Bilt TB516 EC User Manual

Troy-Bilt TB516 EC
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
PART NO. 769-06075 P00 (09/10)
NEED HELP? CALL 1-800-828-5500 IN U.S. OR 1–800–668–1238 IN CANADA
TB516 EC
4-Cycle Lawn Edger
IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Remove Unit From Carton
Start The Unit
Assemble The Unit
Remove the oil plug from the
crankcase, and pour the
entire bottle of oil into the fill
hole.
Place unit on a level surface
and fill fuel tank. DO NOT
overfill.
For cold weather conditions
(below 40°F), push the red
cold weather start lever
down to the closed position.
DO NOT push this lever
down if the temperature is
above 40°F.
Press primer bulb 10 times,
or until fuel is visible
Stand in the starting
position.
Pull the starter rope in a
controlled motion until the
unit starts.
Wait 60 seconds.
For cold weather conditions
(below 40°F), pull the red
cold weather start lever
back up to the open position
after the unit starts.
Tip the unit back so the
blade does not touch the
ground. Squeeze the throttle
control and allow the engine
to warm up for 30 to 60
seconds. The unit may be
used during this time.
11
Remove all contents from
the carton.
5 6 7
19 10
DO NOT squeeze the
throttle.
8
Start The Unit
11
12
13
Align the holes on the upper
shaft with the holes on the
middle shaft. Insert bolts
into the two holes. Install a
washer and knob onto each
bolt. Tighten the knobs
securely. Make sure the “V”
bend in the handle is
pointing up.
3
Slide the ends of the middle
shaft over the ends of both
lower shafts and align the
holes. Insert bolts into the
two holes. Install a washer
and knob onto each bolt.
Tighten the knobs securely.
Keep the cables to the front
of the unit.
2 4
Primer Bulb
10 X
Red Cold Weather
Start Lever
Assemble The Unit
Pull the starter rope through
the eye hook.
Insert the cables into the cable
restraints on the lower and
upper shafts.
DIDN’T START?
IF the engine does not start,
go back to step 9.
IF the engine stops while
squeezing the throttle, go
back to step 10.
Starter
Rope Grip
Fuel Cap
Throttle
Control
On/Off
Control
Handle
Air Filter
Cover
Primer
Bulb
Oil Fill
Plug
Spark Plug
Edger Blade
Blade Shield
Depth
Adjustment Lever
NO TOOLS REQUIRED!
Red
Cold Weather
Start Lever
Red Cold Weather
Start Lever
Español — Page 9 English — Page 1Français — Page 5
Operator’s Manual
Question and Answer IconNeed help?

Do you have a question about the Troy-Bilt TB516 EC and is the answer not in the manual?

Troy-Bilt TB516 EC Specifications

General IconGeneral
BrandTroy-Bilt
ModelTB516 EC
CategoryLawn Mower
LanguageEnglish

Summary

FastGuide

Assemble The Unit

Step-by-step guide for assembling the lawn edger, including connecting shafts and securing parts.

Start The Unit

Instructions for starting the lawn edger engine, covering priming and initial operation.

Safety Information

General Safety Warnings

Essential precautions for safe operation and handling of the unit, including personal protective equipment.

Safety and International Symbols

Explanation of safety alert symbols and pictographs used throughout the manual.

Oil and Fuel Information

Recommended Oil Type

Specifies the correct type and weight of oil for the engine and how to add it.

Recommended Fuel Type

Details the proper fuel to use, including precautions for blended fuels.

Starting and Stopping Instructions

Starting the Unit

Step-by-step guide on how to start the engine, including cold weather adjustments.

Stopping the Unit

Procedures for safely shutting down the engine.

Maintenance and Repair Instructions

Idle Speed Adjustment

Guide to adjusting the engine's idle speed for optimal performance.

Rocker Arm Clearance

Instructions for checking and adjusting valve clearances.

Replacing the Spark Plug

Steps for replacing the spark plug to ensure proper ignition.

Cleaning and Storage

Cleaning the Unit

How to clean the edger after use.

Storage

Guidelines for storing the unit for short or long periods.

Troubleshooting

Engine Will Not Start

Common causes and solutions for engine starting issues.

Engine Will Not Idle

Troubleshooting steps for an engine that won't idle correctly.

Specifications

Unit Specifications

Technical details and measurements of the lawn edger.

Warranty Information

Limited Warranty Terms

Details the warranty period, coverage, and exclusions.

Obtaining Service

Instructions on how to get warranty service and locate dealers.

Related product manuals