EasyManua.ls Logo

TRP HYLEX User Manual

TRP HYLEX
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SAFETY WARNINGS
TRP BRAKES
688 W. Amidan Dr. 4X-1
Ogden, UT 84404
Toll Free: 1-877-807-4162
Direct: 1-650-965-4442
Email: info@trpbrakes.com
Web: www.trpbrakes.com
HYLEX & HYLEX RS
IN STALLATION INSTRUCTIONS
WARNING - This braking system was designed for use on a single rider bicycle. Use of this system on any other vehicle or apparatus will void the warranty, possibly
causing you great personal harm or injury.
WARNING - Disc brakes, calipers and rotors get VERY HOT during regular use. DO NOT touch or attempt to service the rotor or caliper assembly until you’ve allowed for
sufficient cooling to occur.
WARNING - These disc brakes offer a significant increase in performance over traditional cable actuated systems. Follow the break-in recommendations listed in this
manual, allow yourself time to learn and become accustomed to the braking characteristics.
WARNING - Leaking oil indicates a potential BRAKE FAILURE. If you’re system is leaking oil stop immediately and determine the nature of the problem. DO NOT
continue to ride a leaking system.
WARNING - If your bike is involved in a fall or crash, fully check the brake function including: the lever, caliper and rotor are securely attached to the bike, pads are
correctly installed and functioning, the cable, (if applicable) is operating smoothly and the lever feels firm when applying the brake.
Always have a qualified mechanic check the brakes if you have any doubts.
WARNING - Pad thickness must be at least 0.8mm of pad material. Confirm this before each ride.
Keep pads clean and free of oil or hydraulic fluid. If pads become contaminated, discard and replace.
CAUTION - Read this manual completely before attempting to install or work on your TRP brakes. If you are unfamiliar with any element of assembly or maintenance of
this braking system please consult a qualified mechanic for assistance.
CAUTION - Only use TRP or TEKTRO branded replacement Mineral Oil when servicing the brakes. Other disc brake fluids, ESPECIALLY DOT based oils, will harm the system
and compromise braking performance.
CAUTION - Cleanliness is a very important part of any maintenance of a TRP disc brake. If the pads or rotor become contaminated with oil, or if the system becomes
contaminated with impurities, braking performance will be greatly impaired.
CAUTION - As with any oil, precautions in handling and clean up of any spills should be handled according to accepted best practices as governed by your state or
country. Our Mineral oil is non-toxic, but clean up any spills promptly and completely.
If Mineral Oil gets in your eyes IMMEDIATELY FLUSH WITH WATER for several minutes and go to the hospital. If Mineral oil gets on your skin RINSE IMMEDIATELY with soap
and water. Do not inhale Mineral Oil, it is harmful. If inhaled move to a well ventilated environment and proceed to the hospital for appropriate care. If you ingest
Mineral oil it may cause vomiting and/or diarrhea.
TRP hydraulic disc brakes are warranted against manufacturing defects in materials and / or workmanship for a period of two years from the date of original retail purchase.
Not covered under this warranty is damage resulting from improper installation, adjustment or maintenance, lack of maintenance, alterations, crashes or use judged by
Tektro to be excessive or abusive. For warranty related questions or more information please contact a TRP Service Center or e-mail at info@trpbrakes.com
13
32
34
34
13
14
34
70
B
A
A
B
Hylex FlatMount Rear Adaptor & Bolt Lengths
Hylex FlatMount Adaptors Orientations
Hylex IS Mount
Hylex Post Mount
Hylex FlatMount Rear 160 Rotor
Hylex FlatMount
160 Rotor
Hylex FlatMount
140 Rotor
For Post Mount
adaptors, hold the
adaptor so that the
stamped ‘UP’ is
oriented upwards,
or furthest from
the hub axle.
Question and Answer IconNeed help?

Do you have a question about the TRP HYLEX and is the answer not in the manual?

TRP HYLEX Specifications

General IconGeneral
BrandTRP
ModelHYLEX
CategoryBicycle Accessories
LanguageEnglish

Summary

Safety Warnings

General Safety Precautions

Critical warnings and cautions regarding brake use, temperature, leaks, and maintenance.

Adaptors and Hardware

Mounting Adaptor Orientations

Details on orienting FlatMount, IS, and Post Mount adaptors for proper installation.

Rotor and Bolt Torque Specifications

Torque values for mounting rotors and adaptors.

Installation and Adjustment

Tools and Equipment

Lists necessary tools for brake installation.

Rotor Mounting

Instructions for mounting brake rotors to the hub.

FlatMount Caliper Installation

Steps for installing front and rear FlatMount calipers.

Brake Lever Mounting and Adjustment

How to mount brake levers and adjust reach.

Hose Length Modification

Procedure for cutting and reconnecting hydraulic brake hoses.

General Maintenance

Pad Replacement

Guidelines for replacing brake pads based on wear or contamination.

Pre and Post-Ride Checks

Essential checks before and after riding for safety and performance.

Regular Maintenance Intervals

Routine checks including oil level, lubrication, and bolt tightness.

Related product manuals