36
PROBLEM POSSIBLE CAUSES STEPS TO TAKE
Suspension too soft
- Low oil level in fork.
- Oil with excessively low density.
- Rear shock absorber badly adjusted.
- Add the right oil to the specified level.
- Replace oil with correct density.
- Adjust rear shock absorber.
Handlebar vibration
- Worn tyre, swinging arm or bearings worn.
- Rim off-centre.
- Badly aligned wheel.
- Steering shafts, handlebar supports or fasteners with play.
- Take bike to a specialist garage.
- Take bike to a specialist garage.
- Take bike to a specialist garage.
- Tighten nuts and fasteners to specified torque.
Brakes working badly
- Pads worn
- Discs worn.
- Loss of brake fluid.
- Brake fluid in bad condition.
- Master cylinder piston worn.
- System incorrectly adjusted.
- Change pads
- Change discs.
- Check circuits. Replace leaking parts and top up fluid to the
correct level.
- Remove brake fluid circuit and replace with fresh fluid of the
right type.
- Replace master cylinder piston.
- Adjust brakes.
Fusing bulbs - Voltage regulator problems. - Check connections. Check voltage regulator and fuses.
To Next Page
Loading...
