6
4
Changing indicator settings with
Data Link
You may want to change the indicator settings depending on your weighing scenario.
This is a quick and simple process using Data Link on your mobile device or
Windows* computer.
Selecting non-Tru-Test load bars
The S3 indicator is pre-calibrated to work with leading non-Tru-Test load bars.
1. Plug your load bars into the indicator.
2. Connect to the indicator using Data Link on your mobile device or Windows*
computer.
3. Select
to open Settings, and go to the Load bar type menu.
4. Select your load bars from the list that appears.
If your load bars are not on the list, you need to perform a span calibration.
Span calibration
If your load bars are not available for selection on Data Link, you will need to perform
a span calibration to ensure that your animals are weighed correctly.
1. Connect to the indicator using Data Link on your mobile device or Windows*
computer.
2. Select
to open Settings, and choose Span calibration.
3. Follow the steps to complete the span calibration.
To Next Page
Loading...