Wuxi Truckrun Motor Co.,Ltd
Wuxi Truckrun Motor CO.,Ltd reserves the right of final interpretation
4） Gears options
Press 0.5S “UP/DOWN key”，Switch assist gears, change motor’s output power,
The default display is 0-5gear (or customized), gear 0 means stop output power, gear
1 means the lowest power output, gear 5 means the largest output power. No limited
fastest speed at every gear, it can be customized .
Power on , the display is 0 gear in default.
5） Switch mileage show
In default, single TRIP is km/h, press 0.5S “MODE Key” switch to ODOmeter(total
trip mileage) , Press 0.5S“MODE” again，Switch to REST trip mileage，Loop switch show.
Gear 0 and assist walking rest trip is infinity, Trip place no signal.( If the controller
without this function, no signal all the time) .
To Next Page