GDM FREEZER / REFRIGERATOR truemfg.com
TEC_TM_105 | REV. D | ENP#97553605/16/2023 Page 34 of 40
Maintenance & Servicing (cont.)
Slide Door Removal (cont.)
4. Slide the left door to the right and align the right edge with
the end of the TRUE Logo at the top of the door frame
(see fig. 6). Then lift door out of track same way as fig. 4.
5. Remove the door cord from the roller bracket. See figs. 7 and 8.
NOTICE ›
The door cord will either be nylon cord or metal
cable. The black plastic tab holding the door cord slides out
the back.
6. Let the door cord slowly retract back into the door side
channel.
7. When reinstalling the door, be sure the door cord grommet
attaches to roller slot closest to the pulley. See fig. 9.
Fig. 8. Slide the black tab holding the door cord out the roller bracket’s back.
Fig. 9. Be sure the door cord is in the roller slot closest to the pulley.
Fig. 7. Remove the door cord from the roller bracket.
Fig. 5. Align the right door’s left edge with the TRUE logo’s left edge.
Fig. 6. Alight the left door’s right edge with the TRUE logo’s right edge.
To Next Page
Loading...
Need help?
General
