True TSX - Cleaning the Equipment; Storing the Chest Strap; Long Term Storage

truefitness.com / 800.426.6570 / 1.636.272.7100
30
Chapter 5: Care & Maintenance
Care & Maintenance:
It is important to perform the minor maintenance tasks described in this section. Failure to maintain the
elliptical as described here could void the TRUE Fitness Warranty. To reduce the risk of electrical shock, always
unplug the unit from its power source before cleaning or performing any maintenance tasks.
Inspection:
Inspect the elliptical daily. Look and listen for loose fasteners, unusual noises, worn or frayed power cords, and
any other indications that the equipment may be in need of service. If you notice any of these, obtain service.
Important: If you determine that the elliptical needs service, make sure that the elliptical cannot be used
inadvertently. Unplug the power cord from its power source. Make sure other users know that the elliptical needs
service.
Cleaning the Equipment:
TRUE recommends the elliptical be cleaned before and aer each workout. Use mild soap and water to dampen
a so cloth and wipe all exposed surfaces. is helps remove any dust or dirt.
CAUTION: Do not use any acidic cleaners. Doing so will weaken the paint or powder coatings and
may void the TRUE Fitness Warranty. Never pour water or spray liquids on any part of the elliptical. Allow
the elliptical to dry completely before using. Frequently vacuum the oor underneath the unit to prevent the
accumulation of dust and dirt, which can aect the smooth operation of the unit.
Storing the Chest Strap:
Store the chest strap in a place where it remains free of dust and dirt such as, in a closet or drawer. Be sure
to protect the chest strap from extremes in temperature. Do not store it in a place that may be exposed to
temperatures below 32° F (0° C). To clean the chest strap, use a sponge or so cloth
dampened in mild soap and water. Dry the surface thoroughly with a clean towel.
Long Term Storage:
When the elliptical is not in use for any length of time, Make sure that the power cord is unplugged from the
power source and is positioned so that it will not become damaged or interfere with people or other equipment.