CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
13
BIKE ASSEMBLY STEPS
(continued):
Step 2: Front Stabilizer Bar (continued):
b) For each screw, install through split washer
then flat washer
c) Insert Front Stabilizer into the metal bracket
Install each screw through the bottom of the
metal bracket, then through the Front Stabilizer
d) Tighten using the provided hex wrench
Hardware Required:
2 M8 x 70 Screws
2 M8 Washers 2 M8 Spring Washers
a) Attach the Seat Saddle to the Seat Post.
b) Adjust Seat Saddle position.
c) Tighten using the provided wrench.
Preparation for Step 4:
a) Install the Mast Boot component (including
rubber gasket) onto the Front Mast tube
b) Verify that the Mast Boot is installed in the
correct orientation as shown.
To Next Page
Loading...
