Cutting Circles
Changing The Blade
(additional blade cartridges sold separately)
1-800-264-0644 www.graceframe.com
1. The best circles are cut with a single smooth motion,
without stopping and starting again. Place one hand on the
sizing knob. The sizing knob will be the center of your circle.
3. Apply pressure to the blade and sizing knobs, and in one
smooth motion, rotate the blade knob in a full circle.
2. Place your free hand on the blade knob, crossing over
your other arm.
Release
Lever
Blade Cover
Old Blade
New Blade
1. While pushing the release lever to the side, lift up
on the blade knob and reveal the blade.
Warning: Always make sure the blade cover is on before removing or replacing the blade cartridge.
3. Insert the new blade untill it clicks in place.
2. Make sure the blade cover is on, and then remove
the old blade by pulling it out of the TrueCut 360°.
4. Remove the blade cover by twisting a little and
pulling. Keep it in a safe place.
To Previous Page
Loading...