42
34020-01190 - 01 - 03/2022
Finishing work Combi D
EN
If the filling function was unsuccessful at initial start-up
of the Combi D (error code “565”), it can be restarted
once via the control panel. To do this, observe the com-
plete description in this section.
If error code 565 is displayed again after the second at-
tempt, contact Truma Service.
You cannot restart the filling function via the control
panel if filling is completed successfully. If required,
use the Truma Diagnose Tool after repair / mainte-
nance work on the fuel supply.
4 Finishing work
Indicate the year when the equipment was first put
into operation with a tick on the type plate.
In accordance with the operating instructions, check
all functions of the appliance, especially draining the
water.
The operating instructions must be handed over to the
vehicle owner.
The installer or vehicle owner must affix the yellow
sticker with the warning information, which is enclosed
with the appliance, in a location in the vehicle where it
is clearly visible to all users (e.g. the wardrobe door).
Missing stickers can be requested from Truma.
To Next Page
