To Next PageTo Next PageWhat to do if Truma GO2 RH 2 Automobile Accessories fault cannot be rectified after checking batteries?
If you are still experiencing issues with your Truma Automobile Accessories after checking the batteries, try performing a reset. Disconnect the battery briefly for approximately 10 seconds, then reconnect it.
Why Truma GO2 RH 2 caravan battery is not in perfect condition?
The caravan battery of your Truma Automobile Accessories may not be in perfect condition or fully charged due to cold ambient temperatures, which can cause battery performance to deteriorate. To resolve this, ensure the caravan battery is in perfect condition and fully charged.
General| Brand | Truma |
|---|---|
| Model | GO2 RH 2 |
| Category | Automobile Accessories |
| Language | English |
Explains symbols used in the manual for warnings, notes, and important information.
Provides crucial safety guidelines for operating the manoeuvring assistant and handling the caravan.
Offers general advice, limitations, and usage context for the manoeuvring assistant.
Lists recommended battery types and minimum capacities for optimal system operation.
Provides essential tips for maintaining batteries to ensure a long service life.
Offers important notes and safety precautions to be observed when handling batteries.
Details how to turn on the remote control and its LED indicators for system readiness.
Explains how to use the slide control for smooth forward and reverse movement.
Describes using the control knob for precise turning and rotation of the caravan.
Explains how to combine control knob and slide control for various caravan movements.
Details the meaning of LED blink codes and audio signals on the remote control.
Guides on how to properly change the batteries in the remote control.
Instructions for environmentally friendly disposal of the remote and batteries.
Step-by-step guide on how to manoeuvre the caravan using the system.
Lists common issues and checks to perform before contacting customer service.
Provides instructions for re-tuning the remote control and control unit.
Outlines the conditions under which warranty claims are applicable or not.
Defines the duration and coverage of the warranty.
Provides instructions on how to initiate a warranty claim.
Specifies the minimum clearance requirements for installing the manoeuvring assistant.
Explains how to measure the caravan's frame height for correct installation.
Guides on identifying the correct installation type based on chassis and frame.
Lists the necessary tools and equipment for installing the manoeuvring assistant.
Instructions for installing a 30 mm spacer kit for height compensation.
Instructions for installing a 60 mm spacer kit for height compensation.
Guidance on fitting the low chassis kit for specific frame heights.
Instructions for the short version of the low chassis kit.
Details the use of the adapter kit for AL-KO Vario III/AV chassis.
Instructions for the AL-KO M short adapter kit for specific chassis.
Information on the AL-KO M adapter kit for axial displacement.
Instructions for installing the adapter kit for Eriba Touring chassis.
Details the essential adapter kit for Eriba Touring Troll chassis.
Information on the short mounting system for space-constrained installations.
Guidance on choosing the optimal mounting location for the assistant.
Instructions for adapting or fitting mudflaps after installation.
Steps to modify mudflaps to accommodate the manoeuvring assistant.
How to determine and create cut-outs for mudflap fitting.
Checks and preparations needed before fitting the drive elements.
Instructions for attaching the drive units to the caravan chassis.
Steps for connecting the pipes and attaching the toggle crank.
Instructions for centering and tightening the central pipe.
Procedure for engaging and disengaging the drive rollers.
Diagrams illustrating the wiring for installation in front of and behind the axle.
Guidelines for routing and connecting the drive motor cables.
Instructions and warnings for connecting the 12V battery to the control unit.
Steps to verify the battery and system operation after connection.
