• Plug in the lead wire into the unit on the left or right side. without removing the electrodes from the plastic
card, plug two electrodes into the lead wire. The electrode pads may require some pressure to connect to
the lead wire.
• Remove the electrodes from the plastic storage sheet and place them on a test area ( the forearm works
well ) 2 - 4 inches apart.
• You may choose to use either the left side, or the right side of the unit, or both, but the electrodes must
be used in pairs to work. That is, you cannot use one electrode from each side of the unit.
•Your truMedic Electronic Pulse Massager is ready to use!
• Raise the wheel on same side you plugged in the lead wire to "1" and verify that the letter "P" appears on
the LCD screen. Raise the intensity wheel SLOWLY to increase intensity. If a "P" does NOT appear on the
screen, check or replace batteries.
• Turn off the unit, place the pads on the desired area for treatment and turn the unit on to "1".
Next, select one of the "Auto-Procedures" or "Massage", "Beat", or "Knead" buttons and slowly raise the
intensity wheel to the desired level.
6
To Next Page
Loading...
