Trumpf TruBend 2100 User Manual

Chapter 1
Safety
1 For your safety 1‐3
2 Operational safety 1‐4
2.1 Intended use 1‐4
2.2 Authorized personnel 1‐5
3 Hazards 1‐6
3.1 Dangers due to the open electrical cabinet 1‐6
3.2 Hazards due to laser radiation 1‐6
3.3 Dangers handling workpieces 1‐7
Sharp-edged workpieces 1‐7
Upper and lower tool 1‐7
Flange of the workpiece 1‐8
Positioning the workpiece 1‐9
Falling workpieces 1‐9
Improper handling of flat workpieces 1‐10
Improper handling when bending boxes 1‐10
B1161en 2019-07-09
Safety
1‐1

Trumpf TruBend 2100 Specifications

General

Brand	Trumpf
Model	TruBend 2100
Category	Power Tool
Language	English

Summary

Chapter 1 Safety

For Your Safety

General safety guidelines and regulations for operating the machine.

Operational Safety

Guidelines for safe machine operation and intended use.

Hazards and Risks

Identification of potential dangers and risks associated with machine operation.

Manufacturer Safety Measures

Safety equipment and measures implemented by the manufacturer.

User Safety Responsibilities

Organizational steps and responsibilities for safe user operation.

Residual Risks Assessment

Chapter 2 TruBend Series 2000 Installation Conditions

Planning for Installation

Installation Site Requirements

Requirements for the physical location where the machine will be installed.

Floor Quality and Flatness

Quality, flatness, and load-bearing capacity specifications for the installation floor.

Electrical Setup

Power Supply Requirements

Commissioning Preparation

Machine Transport Procedures

Procedures and requirements for transporting the machine from delivery to installation.

Machine Installation Process

Procedures for positioning the machine and drilling installation holes.

Positioning and Drilling Holes

Machine Set-up and Alignment

Foot Switch and Network Connection

Final Electrical Connection

Steps for making the final electrical connection to the machine.

Power Cable Installation