Need help?Do you have a question about the Truper CEPEL-3-1/4N and is the answer not in the manual?
Keep work area clean, well lit, and free of flammable materials to prevent accidents.
Ensure proper grounding, avoid wet conditions, and do not force cords to prevent electric shock.
Stay alert, use PPE, and prevent unintentional starting for personal protection.
Use correct tools, disconnect before adjustments, store safely, and maintain properly.
Check for misalignment, keep accessories sharp, and repair damage before use to ensure safety.
Check cord, power outlet, clear workspace, and test blades for safe operation.
Use dust extraction, hold firmly, keep hands clear, wait for speed, and work safely.
Turn off, use rest support, wait for blades to stop, and handle with extreme caution.
Adjust blades to cutting edge, tighten screws, and handle sharp blades with care.
Adjust parallel guide to desired position using the depth adjusting knob for accurate cuts.
Adjust outlet dial, connect dust pouch or vacuum system for efficient shavings disposal.
Set base, wait for speed, hold firmly, push smoothly, and adjust depth for desired finish.
Match work piece edge with notches for precise bevel cuts or chamfers.
Keep tool dust-free, clean ventilation slots, inspect screws, and check power cable for longevity.
Servicing must be performed by TRUPER Authorized Service Centers to maintain safety and warranty.
Periodic check and replacement by qualified personnel, using only original spare parts.
Keep work area clean, well lit, and free of flammable materials to prevent accidents.
Ensure proper grounding, avoid wet conditions, and do not force cords to prevent electric shock.
Stay alert, use PPE, and prevent unintentional starting for personal protection.
Use correct tools, disconnect before adjustments, store safely, and maintain properly.
Check for misalignment, keep accessories sharp, and repair damage before use to ensure safety.
Check cord, power outlet, clear workspace, and test blades for safe operation.
Use dust extraction, hold firmly, keep hands clear, wait for speed, and work safely.
Turn off, use rest support, wait for blades to stop, and handle with extreme caution.
Adjust blades to cutting edge, tighten screws, and handle sharp blades with care.
Adjust parallel guide to desired position using the depth adjusting knob for accurate cuts.
Adjust outlet dial, connect dust pouch or vacuum system for efficient shavings disposal.
Set base, wait for speed, hold firmly, push smoothly, and adjust depth for desired finish.
Match work piece edge with notches for precise bevel cuts or chamfers.
Keep tool dust-free, clean ventilation slots, inspect screws, and check power cable for longevity.
Servicing must be performed by TRUPER Authorized Service Centers to maintain safety and warranty.
Periodic check and replacement by qualified personnel, using only original spare parts.
General| Shoe material | Aluminum |
|---|---|
| Voltage | 127 V |
| Frequency | 60 Hz |
| Cutting width | 3-1/4 inches |
| Maximum cutting depth per pass | 1/8 inch |
| Maximum Cutting Depth | 1/8 inch |
| Weight | 3.1 kg |
| No load speed | 16000 RPM |
To Next Page
