Need help?Do you have a question about the Truper DES-26C and is the answer not in the manual?
Wear protective gear like eye protection, dust mask, safety shoes, helmet, and ear plugs for safety.
Use only TRUPER-certified accessories or spare parts as indicated in the manual.
Follow safety standards for handling fuel, including precautions against fire and skin contact.
Prepare for operation by wearing appropriate clothing and checking the tool and work area.
Guidelines for safe operation, including body positioning, cutting technique, and awareness of surroundings.
Procedures for safely shutting down the trimmer, cooling it, and preparing for storage.
Install the guard by aligning orifices and securing it with a bolt and nut.
Connect the lower shaft to the upper shaft by aligning the safety pin and tightening the locking knob.
Install the auxiliary handle at a comfortable height and tighten the screws.
Set the harness in the handle ring to support the string trimmer on the shoulder.
Replace the cutting string by removing the spool cap, winding new line, and securing it.
Follow procedures for starting a cold or hot motor, including choke and primer bulb use.
Release the lock and throttle trigger, then set the switch to the off position.
Clean ventilation slots and motor cylinder wings periodically to prevent overheating.
Clean the air filter by tapping, blowing, or washing it in soapy water.
Check the gasoline filter frequently and replace it if dirty.
Replace the spark plug annually or as needed, ensuring proper gap and installation.
Clean exhaust and muffler deposits at an Authorized Service Center if power loss occurs.
Recommended to have carburetor adjustments made by a TRUPER Authorized Service Center.
Wear protective gear like eye protection, dust mask, safety shoes, helmet, and ear plugs for safety.
Use only TRUPER-certified accessories or spare parts as indicated in the manual.
Follow safety standards for handling fuel, including precautions against fire and skin contact.
Prepare for operation by wearing appropriate clothing and checking the tool and work area.
Guidelines for safe operation, including body positioning, cutting technique, and awareness of surroundings.
Procedures for safely shutting down the trimmer, cooling it, and preparing for storage.
Install the guard by aligning orifices and securing it with a bolt and nut.
Connect the lower shaft to the upper shaft by aligning the safety pin and tightening the locking knob.
Install the auxiliary handle at a comfortable height and tighten the screws.
Set the harness in the handle ring to support the string trimmer on the shoulder.
Replace the cutting string by removing the spool cap, winding new line, and securing it.
Follow procedures for starting a cold or hot motor, including choke and primer bulb use.
Release the lock and throttle trigger, then set the switch to the off position.
Clean ventilation slots and motor cylinder wings periodically to prevent overheating.
Clean the air filter by tapping, blowing, or washing it in soapy water.
Check the gasoline filter frequently and replace it if dirty.
Replace the spark plug annually or as needed, ensuring proper gap and installation.
Clean exhaust and muffler deposits at an Authorized Service Center if power loss occurs.
Recommended to have carburetor adjustments made by a TRUPER Authorized Service Center.
To Next Page
General
