Code
Description
Net weight
Motor
Motor rated power
Fuel tank
Speed
Cutting capacity
Axis length
DES-330
11029
19.8 lb
Gas brushcutter
0.23 gal
1.4 Hp
9000 RPM
18”
5.2 ft
Cutting systems
Blade diameter
Nylon line diameter
Nylon line spool and blade
Outer: 10” Inner: 1”
From 0.09” to 0.14” (recommended)
Type of handle
Work cycle
“Bicycle” type
20 minutes rest per each tank consumed.
Maximum 6 hours daily.
33 cc
3
ENGLISH
• The brushcutter has an air-cooled 2-cycle motor using a mix of unleaded gasoline and high quality self-propulsion
oil for air-cooled two-cycle motors.
• The motor is certified to run with unleaded gasoline for vehicles with 87 or more ([R+M]) octane level.
• Do not use any type of gasoline premixed with oil bought in service stations such as gasoline for motorcycles.
• Do not use automotive oil or oil for 2-cycle outboard motors oil.
• The mix ratio should be 50 parts gasoline per 1 part oil (50:1 ratio). Prepare the mix in a gasoline-approved
container. Always mix thoroughly before pouring in the motor tank.
Do not use fuel mix stored longer than 15 days. Make small amounts of mix.
Never smoke near fuel, the gasoline filling up area or where the oil mix is being prepared or when
operating the tool.
Any attempt to start the brushcutter with no oil added to the fuel mix will damage to the
brushcutter.
WARNING
CAUTION
WARNING
Mix
1 liter
1L
+ =
50:1
ratio
4 capfuls oil
Gasoline
A wrong mix may cause the motor to throw a rod causing
expensive repairs!
To prolong the useful life of the motor use two-cycle synthetic motor oil.
* 1 gallon = 3.78 liter ** Not included
Technical data
Fuel specifications
Use ACES-2, ACES-5 or ACES-20 oil caps** to measure the mix.
Mix 4 capfuls oil per each gasoline liter.
To Next Page
Loading...