Truper GEN-55X - User Manual

Questions and Answers

C
Courtney RojasAug 12, 2025
Why is my Truper Inverter motor not starting?
- M
  mweissAug 12, 2025
  There are several reasons why your Truper Inverter motor might not be starting: * The switch might be off: Ensure the switch is in the 'ON' position. * Insufficient fuel: Refill the generator tank. * Connected loads: Disconnect any loads from the generator. * Spark plug issue: Check the spark plug for spark. If there's no spark, replace the spark plug. If a new spark plug doesn't work, take the generator to your nearest TASC. * Fuel not reaching the carburetor: Check fuel flow by setting a container under the drain tube, turning on the fuel tap, and loosening the drain bolt. If gasoline flows freely, try starting the motor. * Low oil level: Inspect and replenish the oil level if needed. If the motor still doesn't start, take it to a service center.
K
Kyle ScottAug 22, 2025
What to do if the overload thermal protector activates on my Truper Inverter?
- D
  Devin McdowellAug 23, 2025
  If the overload thermal protector activates when you connect equipment to your Truper Inverter, it could be due to: * Damaged equipment: Ensure the equipment you are connecting is in good working order before connecting it. * Exceeding generator capacity: Check the power capacity of the connected equipment. If necessary, reduce the load and wait a few minutes before resetting the overload protector. If the problem continues, take the Inverter to your nearest TASC.
M
Michael JohnsonSep 1, 2025
Why does my Truper Inverter motor start and then unexpectedly stop?
- T
  Tammy HamiltonSep 1, 2025
  The motor of your Truper Inverter might start but unexpectedly stop due to a low oil level. Check the oil level and restart the motor.