8
ENGLISH
Maintenance
• Keep the motor housing ventilation slots clean and
uncovered.
• Apply compressed air after each use.
• In case of malfunctioning go only to a
Authorized Service Center
Cleaning and care
Carbon brush replacement
• Replace worn (burnt, broken or smaller than 0.19” long)
carbon brushes. Use new carbons.
• When replacing carbons always replace both carbons at
the same time.
• To access the worn carbons, first remove the carbon´s
cover with the help of a flat screwdriver
• Place the new carbons (They should fall into the carbon
holders easily and slide without getting stuck).
• Place the cover again and allow the machine to run for a
few minutes without workload so that the carbon brushes
adjust better.
• Use only original spare carbon
brushes, designed specifically with the right strength and
electric resistance for each type of motor. Carbon brushes
with different specifications may damage the motor.
To Next Page
Loading...
