Truper PIPI-33E - Troubleshooting

10
ENGLISH
Troubleshooting
The material is not
coming out from the
nozzle .
The material drips out
from the nozzle.
The spray is too thick.
The spray jet is
coming out irregularly.
The coating produce
“tears”.
The material is
producing too much mist
(Over- spraying).
• The nozzle is blocked.
• The suction pipe is blocked.
• The position of the volume selector is facing
totally down (-).
• The suction pipe is loose.
• There is no pressure accumulated in the
container.
• The nozzle is loose.
• The nozzle is worn.
• The nozzle seal is worn.
• The coating material is built up in the spray
diffuser, the nozzle or the needle.
• Viscosity in the coating material is too high.
• Volume of the material is too much.
• The volume selector position is totally up (+).
• The nozzle is contaminated.
• The air filter is very dirty.
• Not enough pressure accumulated in the
container.
• The container is getting empty.
• The air filter is too dirty.
• Too much coating material was applied.
• Too much distance away from the
object.
• Too much coating was applied.
• Clean the nozzle.
• Clean the suction pipe.
• Turn the selector up (+).
• Install the pipe correctly.
• Tighten the container.
• Tighten the nozzle.
• Replace the nozzle.
• Replace the nozzle seal.
• Clean the build up.
• Thin the material (see page 7).
• Turn the volume selector down (-).
• Turn the volume selector down (-).
• Clean the nozzle.
• Replace the filter.
• Tighten the container.
• Fill up the container again.
• Replace filter.
• Turn the volume selector down (-).
• Reduce the distance.
• Turn the volume selector down (-).
Problem Cause Solution
If the problems cannot be solved despite the recommended corrective actions
visit a Authorized Service Center.