Danger: To help prevent severe personal injury or death:
o Read and understand instructions completely before beginning
installation.
o When connecting the Sentry 2 system to accessories, read the
installation instructions supplied with each accessory before
beginning installation.
o Save ALL instructions.
o Installer – please be sure to give ALL instructions to the
homeowner once installation is complete.
o
Wiring must be installed by a qualified electrician according to local
and National Electrical Codes (N.E.C.)
o
Disconnect main power before beginning installation! Verify that
power is OFF at the main breaker or fuse panel by testing with a
voltage meter that you know is working correctly.
o
Connect power only after motor connections and settings are
verified.
o
This equipment does not provide a method to shut off power, and
should be connected to a dedicated breaker or fused power circuit
capable of providing 50 watts of power per control.
o
The Sentry 2 system must not be used on windows intended to
meet egress codes.
o
The Sentry 2 system is intended for indoor use only, with screens in
place.
o
The screen interlock MUST be correctly mounted and is a required
part of the installation on windows/skylights less than 8 ft from the
floor. It is intended to help prevent injury that could result from
reaching into the window or skylight opening during operation.
o Do not allow children to operate the wall push buttons or remote
control transmitter(s).
LANGUAGES
ENGLISH PAGE 1
FRANÇAIS PAGE 39
Made in USA
An FKI Industries Company
700 West Bridge Street
Owatonna, MN 55060
1-800-324-4487
www.truth.com
Form 90063 R1
Window or Li
ht Skyli
ht
Motorization System
Installation Instructions
Sentry II WLS®
ESPAÑOL PAGINA 20
To Next Page
Need help?
General
