TSM Optimix User Manual

TSM Control Systems,
Ard Easmuinn,
Dundalk, Co. Louth, Ireland
Tel: (+353) 42-9335560 Fax: (+353) 42-9334422
Email: info@tsm-controls.com
Website: www.tsm-controls.com
Initial Setup – Starting the Blender
The following sequence should be completed on initial power up of the
blender.
1. Power up
• Connect mains power lead. (Please
read the safety information in the
introduction section for warnings
and the maintenance section
page26-29 for the electrical
connections)
• Check that the operator display is
showing the home screen
• The TSM blender range are
designed to allow easy operation
for operators of all nationalities.
The system operation therefor
uses internationallly recognised
symbols.See user manual for
symbol descriptions
Home screen
System Menu
Touching the home icon allows the user to return to the
home screen from any screen
Doc no TD 107 Rev 1.1
Page 1

TSM Optimix Specifications

General

Brand	TSM
Model	Optimix
Category	Monitor
Language	English

Summary

Blender Initial Setup

Power Up and System Check

Connect mains power, read safety information, and confirm the operator display shows the home screen.

Blender Calibration Procedures

Weight Hopper Calibration

Calibrate the load cell by opening the front door and entering the supervisor password (default 5560).

Tare Hopper and Set Zero Point

Ensure the mixing chamber door is open and tare the load cell to establish the zero reference point.

Verify Weight Calibration

Place a known weight and enter the value to confirm the actual weight displays correctly.